Fan is not reversing. What would cause this ?
Answer HI Stephan. Are you talking @ the convection fan ? Part # 9781543. You need to check at the terminals to see if the motor windings ohm out between 9-13 ohms. Are you getting 120 vac from the clock in conv. bake to the fan. If so then your clock and feed wires are good. If you are not, then check the wires for a loose connection or pinched wire. You need to verify getting 120 vac out of the clock at the blue wire at J1-6 connection. If that you are talking about the cooling fan that is mounted in the front lt. side panel (at the front lower corner). It should ohm out to 55-75 ohms. It is part # 9751020. It gets its power from the bi-metal thermostat part # 9759944. It should close at 140° to the fan. The bi-metal is a normally open thermostat. Thank You