24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Wire Harness, Microprocessor by Whirlpool

    • Part Number: AP4113594
    • MFG Part Number: 99002986
    • Made by: Whirlpool
    • Not Available

Questions & Answers

For Whirlpool Wire Harness, Microprocessor (Part Number: AP4113594)

Ask a Question

Most Interesting  |  Latest Questions

Ordered replacement door latch assembly. When I tried to detach the micro switches from the old one, one of the switches fell apart leaving the metal connectors in the white connector that is attached to the wiring. I cannot get the connectors out of that white box. What do I do ? Is there a "trick" to getting those blades out of that connector? HELP !!!

MISSLE526 for Model Number ADB1500AWW

Answer

Was this helpful?

1 Answer

I turned on my dishwasher and everything was fine. I noticed that five minutes later it wasn't working. I opened it up and it was filled with water. I tried pushing the start/stop button and noticed now none of my buttons work. I checked the power supply and it is receiving power. Do I need to replace my control panel?

Hartsell for Model Number ddb1501awz

Answer

Was this helpful?

1 Answer

Can you check continuity on touch pad? Which circuit is the ground or hot wire on the touch pad circuits

John B for Model Number MDB6601AWW

Answer

Was this helpful?

1 Answer

The dishwasher only runs in the rinse mode. If you select any mode other than rinse the green light will light up next to the mode you just selected, then 3 to 6 seconds later the green light will switch over to the rinse cycle. The only mode it will run in is the rinse cycle. Is my problem the touch pad or the control board or something else? Thank you for the help! Chuck

Chuck for Model Number ADB2500AWB

Answer

Was this helpful?

1 Answer

The dishwasher will fill up,it doesn't run the cycle,it leaves the water in, and kicks off. You can press the start button again and it will show 2, as in minutes left, and it will drain.

Tammy for Model Number MDB7650AWB

Answer

Was this helpful?

1 Answer

DISHWASHER DOES NOT DRAIN AT END OF REGULAR CYCLE. HOWEVER IT WILL DRAIN IF AFTERWARD YOU CYCLE THE RINSE ONLY CYCLE.

Kenneth for Model Number MDB6601AWW

Answer

Was this helpful?

1 Answer

The option buttons to the rt. light up. With no response or lights on the left side or center ( cycles , auto clean, start, delay). I think the touch pad is needing replaced? Or should I check other areas?

Dot W. for Model Number mdbh955aww

Answer

Was this helpful?

1 Answer

The dishwasher will not turn on I can get all of the "buttons" to work except for the start button. Is the control board shot or could there be another part that is messed up?

Rob for Model Number MDBH945AWS

Answer

Was this helpful?

1 Answer

In fixing a handle issue, I had to unplug 2 plugs to release the front panel from door. The plug to the vent does not have ny markings and can be plugged in either way. I am sure there is a correct way, I cannot find any information on the internet to tell mee which prong is ground.

Dennis D. for Model Number MDB6601AWB

Answer

Was this helpful?

1 Answer

 
We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify