24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00
Appliance RepairHotpoint Fault Codes

Hotpoint Fault Codes

Hotpoint Range / Stove / Oven Fault Codes
Failure Code Fault Code Description Solution
F0 Stuck touch pad Usually means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be cancelled, replace the oven control (also called clock or ERC), touch pad, or both.
F1 Stuck touch pad Usually means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be cancelled, replace the oven control (also called clock or ERC), touch pad, or both. Refer to F1 test page for more information...
F2
During
BAKE
Control senses oven temperature above 615F-630F If actual over temperature condition occurred: Look for welded relay contacts on bake or broil relays. If this happens, replace oven control (also called clock or ERC).

If no over temperature condition occurred: Look for a high resistance connection or any other cause of high resistance in the oven temperature sensor circuit. Check sensor, sensor harness and sensor harness connection at sensor and oven control. Replace sensor if found defective.

Remember: Oven control (ERC) measures resistance of sensor circuit, not actual oven temperature.
F2
During
CLEAN
Control senses oven temperature above 915F-930F If actual over temperature condition occurred: Look for welded relay contacts. If this happens, replace oven control (also called clock or ERC).

If no over temperature condition occurred: Look for a high resistance connection or any other cause of high resistance in the oven temperature sensor circuit. Check sensor, sensor harness and sensor harness connection at sensor and oven control. Replace sensor if found defective. Check door lock switches.

Remember: Oven control (ERC) measures resistance of sensor circuit , not actual oven temperature.
F3
or
F4
Open or shorted oven temperature sensor (RTD) Check sensor harness and harness connection between oven sensor and oven control. Replace oven temperature sensor (RTD) if wiring is ok.
F7 Stuck touch pad or bad clock Usually means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be cancelled, replace the oven control (also called clock or ERC), touch pad, or both.
F9 Lock switch Check wiring to door lock switch (the wire harness may be connected wrong). Check for stuck lock switch.
Find Parts
^ top
We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify