Agitator W

Randall N. for Model Number Lat 9314 aa e

Answer Hello Randall, There is a hidden screw in the side of the agitator. It has a 1/4 inch hex head. It doesn't have to be removed, only loosened. This will allow you to easily lift the agitator out of the unit. To correct the leak, the outer tub seal 6-2095720 and tub bearing 6-2040130 need to be replaced. 

Ted for Model Number ap4023955

Answer Hello Ted. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx 

Victor for Model Number A9700

Answer Hi Victor. Remove power. Remove the front panel. Lift the unit up and support it. You are probably smelling the belts burning part # 12112425. Remove the belts and rotate the pump part # 6-2022030, motor part # 12002353. and the main pulley. The main pulley will rotate and click one way. The opposite way it will compress a brake spring to lift the brake pads so the unit can spin. Thank You. 

Rebecca for Model Number a9700s

Answer Hi Rebecca. Remove power. Tilt the unit and support it on its back. Remove the belts. Rotate the pump and motor in both directions to see if they spin freely in both directions. Rotate the main trans. pulley (clockwise) and it should rotate the agitator back and forth. The opposite way (counterclockwise) should lift the brake rotor off the stator and spin the inner tub assy. freely. You can also lift the top and unclip the top tub ring. Use a flashlight to look down inside the tub and see if there is a balled up piece of clothing stopping the tub spin out. Remove a side 1/4 " bolt from the agitator, lift out and see if there are clothing bunched there possibly. Let us know what part you might need. Thank You. 

Abel for Model Number LA9900

Answer Hello Abel. You should be ok with the tightening of the tub nut. Check the brake assembly and make sure it is releasing properly. If it is not, then you will need to replace the brake assembly. 6-2011900 Hope this helps. 

Roy for Model Number lat8600aaw

Answer Hello Roy. Check and see if the agitator has marks on the bottom of it where it is rubbing the tub. If so, you have a bad transmission. Hope this helps.