None of the Wash, Spray arms and Spinner (3rd level wash) will spin (rotate) during any cycles. The wash tub will fill with water up to the limit and also it will drain. The Sensing light is on for a considerable time.
What can be wrong?
Answer Hi Stan. Is the rear water tube going up the back wall connected to the back of the wash plate ? Remove the front lower kick plate and see if when you are in the wash cycle the motor assy. is energised. If not then verify with a volt/ohm meter for 120 vac on the blu/wht and blu/red wires. If you are getting 120 vac from the control board then you know the board and the wires to the motor are good. Motor part # W10757217. Check board output on the p5 and p9 for 120 vac. If not then you will need to replace the control board part # 8564543. Remove the top sump covers and See if there are debris stuck in the impeller blades or at the chopper blade. This will stop pressure also. Thank You.