Main bearing going out Jason C. • Alva, OK • November 20, 2014 Appliance: Amana Washer-Top Loading DLW330RAW My Repair & Advice All the talk of a loud washer sounding like a jet taking off in the laundry room, well this is the fix. Kind of a complicated repair but just follow the instructions and you'll breeze right through it. Figure if you're about to tear into a washing machine and DIY you got this handled. Get the washer to a wide open room, I used the garage, and take the whole thing apart. Don't try to fix it with the side panels attached, it will be a pain in the butt. There are a few special tools needed but if you're clever you can work around that. A deep 1 1/2" socket and driver will come in real handy, otherwise you'll need a special tool to remove the main nut holding the whole project together. Make sure you get the hub and seal kit along with the bearing because you'll need it. Had mine torn apart and put back together in a little over three hours, but there were a few adult beverages involved to make things go smoother Was this review helpful to you?