What causes washer to only fill when on hot or warm cycle?
Cold water will not run in tub.
Gloria for Model Number V61J2L4G
Answer Hello Gloria. Test for power to the cold water valve and make sure the screens are not clogged. If there is power and the screens are clear, replace the water valve on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
I want to replace the Main Control Board #10367783 on a Whirlpool Top Load Washer #WTW4850XQ. How do I remove this component?
Jeff for Model Number wtw4850xq
Answer Hi Jeff. Remove knob and the hidden screw Lt. of center on the timer shaft. Remove the control back cover. Use a plastic putty knife to slide in under the front lt. and rt. lower control panel end caps. It releases both clips one at a time to hold up and then pull the control panel fwd. 1/2''. Lift up and off from the cabinet top. Place a towel on top of the unit to lay it face down on a towel to protect it. Then use a cell phone camera to picture all electrical connections B/4 removing for proper placement in the future. Use a pen and paper if necessary. Then be careful to not touch the inside of the new board. NOTE= REMOVE BODY STATIC BY GROUNDING YOUR HANDS TO BARE CABINET A FEW TIMES. This removes static and lowers chances of inducing ^ 30,000 volts and ruining the new board. Touch only the outer sides until mounted properly. Make sure all connections are tight. Main control board part # W10480186. Thank You.
The washing machine occasionally tries to spin, makes a loud noise. Definatley not the lid switch. Belt? Do I get in from the back?
Patrick for Model Number Roper 2002
Answer Hello Patrick. You will lean the washer backwards to check the motor coupling and if good, you may need to replace the clutch kit in the unit.