I have a simple non digital gas stove. Top burners & electric igniters are working ok. Oven igniter is working ok also but I can't get the oven burner to come on. Igniter stays on though. What could be the problem? Please help.
Joe for Model Number ?
Answer Hello Joe. Test for 3.2-3.6 volts AC at the gas safety valve with the igniter turned on. If the voltage is there, you have a bad safety valve. If the voltage is low, you have a weak igniter and the igniter will need to be replaced. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
MAking very loud roaring noise during spin cycle. Removed both tubs and activated spin cycle, still hearing noise, sounds like the main bearing under the trans. above clutch/brake. How do I remove and replace if this sounds like the problem?
Jeremy for Model Number LAT9356AAE
Answer Jeremy, On that unit you most likely will need the tub bearing and tub seal assembly 6-2095720 and 6-2040130 and a spanner wrench to do the repair TJ90TB123A. A lower radial bearing seldom goes bad, unless you've had a leak and washed all the lubricant out of the bearing. Remove the front panel and isolate the location of the noise, At or neear the bottom of the tub assembly,tub bearing/seal at the base of the machine the radial bearing. Good Luck and Thanks