Im trying to find out how to install part number AP4567545, the bellow for a whirlpool washer.
Jason S. for Model Number WFW94HEXW0
Answer Hello Jason. 1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover and the console.
4. Remove the lower front access panel.
5. Open the washer door.
6. Using a small screwdriver or a pair of
long-nosed pliers, pull the tension spring
on the retaining wire out from around
the front of the bellows W10237494, and remove the
wire.
7. To remove the door switch assembly:
a) Pull the bellows off the lip of the front
panel beside the door switch assembly
just enough to access the switch
assembly.
b) Remove the two T-20 Torx screws
from the door switch assembly.
c) Pull the door switch assembly out and
turn it over so that you can access the
connectors.
d) Unlock the tabs and disconnect the
three wire connectors from the door
switch terminals, then remove the assembly.
8. To remove the bellows:
a) Remove the two T-20 Torx screws
from the door switch assembly.
b) Remove the front panel from the
washer.
c) Turn the bellows retaining clamp screw
counterclockwise until the clamp is
loose enough to remove it from around
the bellows.
NOTE: It may be necessary to completely
remove the screw from one
end of the clamp.
d) Remove the bellows retaining clamp
from around the bellows.
e) Pull the bellows off the front of the
tub.
REASSEMBLY NOTE: When you reinstall the
bellows, be sure to position the “weep holes”
at the bottom, as shown below. Hope this helps.