What adhesive is used to install blower housing foam seal?
PART # AP2996662
Answer Hello Dale. There is no adhesive needed to install the blower housing foam seal 347139. You will peel off the brown paper and there is glue under it to install the seal onto the unit. Hope this helps.
How do I go about changing the drum belt?
Answer Hello James. Disconnect the power to the unit and remove the lint filter. Then remove the screws under the lint filter and release the clips under the front corners. Raise the top and remove the screws securing the front panel and unplug the door switch. Lift and remove the front panel from the dryer. Now you can install the belt 341241 on the dryer drum. Here is a link to the dryer belt diagrams. Hope this helps. http://forum.appliancepartspros.com/dryer-repair/25860-dryer-belt-diagrams.html