Blower Wheel

Dave for Model Number medc400vw0

Answer Hello Dave, Check and make sure the drum assembly is not broke or warped. If so, it will cause the issues you are having with the unit. 

Jimmy M. for Model Number maytag bravo 300

Answer Hello Jimmy. You will need to remove the front panel of the dryer and see if the pulley on the top of the blower wheel has come off. If so, replace the pulley and nut and use thread locker to install it. 

Howie for Model Number rex3615ew1

Answer Hi Howie. The blower wheel is part # 694089. As the old saying goes "use a bigger hammer" you can get a 12" long chisel and careful split the wheel in half from the center out. Be care full as to not even get close to the motor shaft. Then hold the belt pulley end of the motor shaft tight as you re-thread the new blower wheel on. Thank you. 

Sam for Model Number rgd444ovql

Answer Hello Sam. Disconnect the power to the dryer. Remove the screws under the lint filter. Then release the clips under the front corners of the cabinet, and raise the top of the dryer. Unplug the door switch, and remove the screws holding the front panel on the dryer. Pull the front panel forward, and lift the front panel off the dryer. You can now access the belt for replacement. Reinstall in reverse order. Hope this helps. 

Sam for Model Number rgd444ovql

Answer Hello Sam. You will need to check and see if the belt 341241 is broken. If so, you will need to replace the belt. Hope this helps. 

Mike for Model Number AED4475TQ1

Answer Hello Mike. This part can be rather difficult to remove. It can be rather tight on the shaft. You would need to find a way to stabilize the motor shaft and with enough twisting, you should be able to unscrew the blower wheel. I hope this info helps.