Water does not come to ice maker and water dispenser. Replaced inlet valve already. The solenoids sound like there going off when dispenser is pressed. Held door switch in the ice maker moved like it was unloading made ice. Does the control board send the signal to the water valves to open to fill ice maker and let water to the dispenser? Not sure what to try next.
The control board does not send the signal for the icemaker but does for the control board. You will want to make sure that you have a good water filter in the unit. If the water filter is new and good, check to make sure that the water supply is turned on. If you have the bypass plug for unit and the water supply is turned on, put bypass plug in and see if water comes through door. If it doesn't then you most likely have a bad filter head.
The water / ice / crushed ice buttons don't work and it is stuck on water. The actuators seem to be on the control board that mounts on the back of the facade. Since the facade is intact I assume I need a new control board?
Answer Hi Brian. The fountain control board controls commands ,part # 67003817. The keypad is most likely not stuck as you have a few issues. Behind the Actuator pad, there is a micro switch that can short and call for water or ice depending on the last command chosen. This is part # 12575501. It wouldn't hurt to lightly use white silicone grease on the actuator pad "finger" as it contacts the switch itself easing operations. Part # TJ055975. Make sure all connections are tight. Thank You.