No display. Unable to use any burners. Can do a "End of Service Test Sequence" if I press one of the burner controls and release it in "LO", "HI" position, but if I set it back to "OFF" the power and display goes blank again. When I set the burner to "Lo" or "Hi" the "control lock" then "PF" comes on, I can then do the "End Of Service Test Sequence". Any ideas??
Dan for Model Number YKESC308LS0
Answer Dan, Sounds more like a power supply issue, than a range or control issue. If your power leg (120 VAC) or the neutral leg is dropping out "under a load" (when you turn a component on) You could get erratic displays and strange operations and read outs. You should get an electrician in , and have him check the power supply at the range "under a load" and go from there. Good Luck and Thanks
The control board displays properly and responds to commands, but the oven burners are not working at all, replaced power board,hear clicking noises and still not heating, top surface elements ok.
Rafael for Model Number KECR608LSS0
Answer Rafael, Based on your post information, you'll need to check for 220/240 volts at the bake and broil element wires, (you'll need to be careful conducting live voltage tests) there could be a broken L2 wire or open in line fuse to the elements causing them not to heat. Everything else sounds proper, based on your post. Good Luck and Thanks
my top burners work ok, but my oven did not work at all. no light at the display. nothing work.
Wilfredo for Model Number kesc307hbs0
Answer Hello Wilfredo. Test and see if the power board 9782437 is sending power to the control board. If so, you will need to replace the control board 9782455. If no power is there, you will need to replace the power board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html