The bake and broil elements will not heat up at all. I checked the power supply and that is good (240 volts). All the wire connections look good. Could this be the bake/ broil relay circuit board or is there something else I should look at? Thank you
This is most likely caused by a bad relay on the bake/broil board 12001691. You can tell with a test meter set to AC voltage if you disconnect the bake wire from the board. There should be 120Vac on both the terminal and the wire. If there is voltage on the terminal using ground as a reference but not the wire leading to the element, the board is good and you should look in the direction of the element. If there is voltage on the wire but not the terminal, the board is at fault.