The dishwasher door won't latch.
Peter for Model Number DU810SWPU3
Answer Hello Peter. You will need to disassemble the door and check the latch bolt 3380854 and see if it is broken on the unit. Also, check the strike on the top of the unit and make sure it is good.
how to install door latch
Tommyfuler for Model Number ruid4000mqo
Answer Tommy, You will need to remove the inner door liner, to access the door latch assembly. Here's some help " 1.. Disconnect the dishwasher from the electrical supply. 2. Disconnect the end of the door springs from the door spring tension adjustment holes in the frame runner. 3. Open the dishwasher door and remove the eight (8) T-15 Torx screws securing the inner door panel from the door frame. 4. Slide the inner door panel back toward the dishwasher to disengage the spring loaded locking tab from the door panel, then lift the door panel away from the door. 4. Remove the control cover." Good Luck and Thanks
The latch on my dishwasher does not work. It worked fine this morning. How do I check to see what is broken ?
Stellam for Model Number 66516769000
Answer Hi Stellam. The door latch is part # 3380854. Bolt, Latch - Lever not included. For black lever order 3369457. For white use 3369457. For biscuit use 3375062. You carefully inspect the door latch /striker area to see why this area has broken. Door Latch Issue : You remove power. Then you get a Torx- 20 size screwdriver to remove the inner panel. Then you will simply pull the latch system off the back side of the console.At this point it simply "sits" in place between The 2- left and right bosses that accept the round side post on the side of the latch body. Unfortunately 90% of the time the back of the console is broken, part # W10254847 . This is caused by the installation may have been incorrect. Remove the lower kick p-late and use a flashlight to see if the back legs are all on the floor snugly. If you have the installation guide it will show how to use a torpedo level and remove the rack. Then place the level on the side support rail to see if the unit is level front to back. Then put the level on the inside of the door panel at the lowest side for the horizontal side to side level. This will allow proper alignment of the door ( a separate part) to the cabinet area. While the unit is full of hot water and dishes, it will "relax" the tub. If the legs are not positioned correctly, this will allow the door and latch area to misaligned and break both the console and the latch itself. So by correcting the level , this will allow the parts to last longer. Thank You.