Burner

Don

Answer Don, the burners like this one 3403M075-10 just twist off but you have to be careful not to break the ignitor as you do it. Hope this helps! 

Mur for Model Number JDS9860A

Answer Hello, here is a link to the conversion process https://www.whirlpool.com/digitalassets/MLPDF/Installation%20Instructions%20-%208101P534-60.pdf . Make sure the conversion was performed properly, however when this unit runs on L.P it will bring down the ratings of the burners to 7,500-9,000 btu's. Thanks! 

Don for Model Number JGD8130ADB

Answer Hello Don, Have the gas valves under the knobs been adjusted? The flame on low should be adjusted to just rise above the burner cap. 

Curt for Model Number jen aire JGD8130

Answer Hello Curt. You will need to check and make sure the burners 3403M075-10 are clear from all debris. If not, you will have the problems you are having. A small piece of rust or dirt can clogg and orifice in the unit. Hope this helps. 

Richard for Model Number JENN-AIR JGD8345ADB

Answer Hello Richard! No, the new burners part number 3403M075-10 do not come equipped with the ignitors 74004053. You should only replace the ignitors if defective on your current burner. Thanks! 

Carole for Model Number JGA8100ADB

Answer Hello Carole. The burners will twist off the cartridge. They can be very tight. Hope this helps.