I received the Burner Assembly part number WPL 279726 (order number 2227413). I would like installation instructions please. The burner assembly was missing part number 21 Sensor Radiant and part 16 Screw, 8-18 X 3/8. I assume I can take these parts from the existing burner assembly. The whole purpose was to convert from Propane to Natural Gas and as the Natural Gas Orifice is no longer available I had to buy this entire unit. Please provide installation instructions. Thanks Tom kalis 734-502-2815
Tom K for Model Number wgt3300sq2
Answer Tom, Here are the basic instructions for replacving the gas valve/burner. " First - be sure to shut off the gas supply and power to the dryer. Disconnect the gas supply pipe from the burner assembly. 1. Remove the wire leads from the igniter and flame sensor. 2. Remove two(2) screws in the front that hold the burner assembly in place. 3. Remove two(2) screws that secure the burner funnel into a collar attached to the bulkhead. 4. Pull the burner assembly forward and out of the unit." Good Luck and thanks
Do I have to spend an outrageous amount to convert my propane dryer to Natural gas? I have 9 of them.
Bob H. for Model Number MGT3800TW1
Answer Hello Bob! If the original parts were not kept you will need to purchase the burner assembly 279726. Thanks!
Do I have to spend an outrageous amount to convert my propane dryer to Natural gas? I have 9 of them.
Bob H. for Model Number MGT3800TW1
Answer Hello Bob! If the original parts were not kept you will need to purchase the burner assembly 279726. Thanks!