Note: This question is for the older version of this part, but we thought you might still find it helpful
My analog meter died a few months back. Purchases a digital meter. In any case I guess I should still see a "C-kick" then slow drop back to zero telling me the capacitor is doing it's job so then it would be that the motor is bad (not starting with the kick from the capacitor)?
Usnavychiefret for Model Number KUDR01TJBT0
Answer Hello USNavyChiefRet. If the digital meter can read the capacitor, then yes, you should see the "C-Kick". If it is good, then the motor may be bad. Check and make sure there is power coming to the motor. Hope this helps.
1 person found this answer helpful.
Note: This question is for the older version of this part, but we thought you might still find it helpful
Dishwasher seems not to fill up or run, drain pump will run. On front panel the start button will flash I think 7 times, and pause on then start flashing again, and the green light on the clean or finish button stays on. The manual said something about the heating element for the clean light but do not understand the flashing light on the start button. Any suggestions would be helpful. Thanks for your time.
Tommy W. for Model Number gu3200xtpso
Answer Hello Tommy. Lets run the machine through diagnostics mode. Press the following keys, in order, in less than 6 seconds, while in standby: Heated Dry, Normal, Heated Dry, Normal. Let the unit run through the test. Try getting your water hot at the sink before operation to prevent this in the future. Hope this helps.
1 person found this answer helpful.
Note: This question is for the older version of this part, but we thought you might still find it helpful
Will this cause the dishwasher not to run or fill up? Part number AP4420627
Guest
Answer Hello. This part will keep the machine from running, but the water should fill up. If you will provide a model number, we can see what might be causing your problems.
1 person found this answer helpful.