I had the clean vent filter code pop-up on my over-the-range range microwave. I cleaned and replaced filters and the "Clean Filter" still pops up. Is there a way to reset it?
Answer Hello Marty,
Reset the filter status after replacing and/or cleaning the filters. Touch Options or Setup control to reach the “Filter Reset” sub-menu and activate reset. To reset control, dis-continue power supply to the unit for 2 minutes and power it back up. If the problem persists, the control board W10211457 will most likely require replacement since the EEPROM read only programming information on it is probably corrupted.
How do it install the charcoal filter. Ap4299744?
Answer Hello Mike. Remove the vent off the top of the unit by removing the screws in the top. Then remove the old filter from the front and install the new filter 8206230A into the unit.