My ice maker is working fine, but when I put a glass in position and press to get ice, the ice comes down the chute, but the "flap" doesn't open to dispense the ice.
Any thoughts? Thank you.
This issue will most likely be caused by a bad solenoid on the dispenser or a broken arm on the door. You will want to install the ice door kit part number 12001991. To access you will need either a #15 or #20 torx bit. Remove the drip tray and take out the 2 screws holding the front panel in place. Pull out on the bottom of the panel and lift up to remove. Make sure that the power is off to the unit. There will be 3 more screws holding the dispenser assembly in place. 2 at the top of the assembly and one by where the pad is on the right side of the pad. Once removed you will pull this assembly out and disconnect the wire harness. Take the wires off the solenoid on the left side and remove the screws holding solenoid in place. You can then lift the solenoid out.