I have replaced both the touch pad and clock and I am still getting F1-7 fault code.
Answer Hello Gene. You will need to check and see if the locking tabs on the control board are lifted so the ribbon cable can be installed all the way down and flat into the connector. Once installed, you will press the locking tabs down to lock into place the ribbon cable.
When oven is set to temp and started it will reach temp then start beepingbut touch pad don't work but f-1 shows on clock
Answer James, There should be more in the display (F1-1, F1-5,etc) There are several possibilities as to what has malfunctioned, and you should conduct the diagnostic codes test to determine the issue. You may have an issue with the oven temperature sensor 12001656 ERC/Clock 74007225 or control panel/keypad assembly [AP4094903}. We'll send you the information so you can program the test and diagnostic modes and determine the issue.