unit is not spinning in spin cycle. water drains and unit rotates as in wash cycle. this problem is intermittent.
Answer Scott, Based on the post, the washer thinks there's an "Off Balnced" load. You want to check the off balance switches and wiring, before you replace the control board. This is a low voltage circuit, and a loose connection can distrupt the circuit. There are three switches, one on top(inertia switch), one on the right side and one on the bottom of the tub, make sure they all have closed circuits, and no loose connection and the plungers move freely. There are two multi plug "molex" connectors one on each side of the tub, under the washer top panel, check and make sure there are no loose connections there as well. Thanks
Mine doesn't stop in the middle of the cycle, it stops progressing through the cycle and continues to run halfway between the 1st & 2nd rinse . . . FOREVER
Answer Rich, A couple of things to check first, check the cold fill hose and valve screens for debris and clogs. Check the water level switch wiring and blow into the air dome hose, to clear any debris. In the washer cabinet, there are two multi plug connectors on each side of the tub, disconnect and check both sides of the connectors for loose wirs and connections. check these first, from there we will need to check the timer and main control board inputs and outputs. Thanks and Good Luck