Cntrl-Elec

Louis for Model Number MER5770AAW

Answer Hello Louis, Unfortunately the manufacturer has changed the control 5701M556-60 to black and the white one is no longer available. Sorry about that. 

Marie for Model Number MER5780bas

Answer Marie, We think you misunderstood the code information/indications. An F9 code indicates an issue in the self clean door latch switches,or wires and not necessarily a faulty ERC(clock). Based on the model number you supplied, you should have a four(4) digit fail code (ie. 9d11 > Lock switch not closed).Checking or replacing the self clean latch assembly is a bit more involved " Maintop Assembly 1. Turn power off to unit. 2. Open oven door and remove screws securing maintop to oven chassis, located on the out side edges of the maintop. 3. Raise the front edge of the maintop and pull forward approximately 6-inches. 4. Disconnect wire terminal plugs from the maintop assembly. 5. Lift maintop assembly from the oven chassis. 6. Reverse procedure to reinstall maintop assembly. Automatic Oven Door Latch Assembly 1. Remove maintop assembly, see "Maintop Assembly" procedure, steps 1 through 5 and "Drip Baffle" procedures (if so equipped). 2. Remove screws securing latch assembly to the front of the oven cavity outer shell. 3. Disconnect and label wire terminals from latch assembly. 4. Remove screws securing latch assembly to the back of the unit chassis. 5. Reverse procedure to reinstall door latch assembly." It's more likely you'll find the issue here than in the ERC. Good Luck and Thanks 

Kaleena for Model Number MER5770BAW

Answer Hi Kaleena. Yes this controls all the command responses as they have relays on this board to relay the voltage to the devices. The part # is 5701M556-60. Thank You. 

Willie for Model Number mer5570aaq

Answer Willie, Have you checked or replaced the oven bulb 8009 Unclip the retainer clip and unscrew the bulb, it's a standar incandescent light bulb, just be cautious , so you don't break anything. Press in on the door switch actuator rod in the upper right hand portion of the oven opening and listen for the switch to "click" as it opens and closes, when you push and release the rod. You will need to raise the cooktop and remove the right side panel of the range, to access the light switch assembly and check the wiring and switch. Thanks and Good Luck