Is there a reset or fuse or breaker on the clock unit & control panel?
Answer Hello Happy cappy. No, if the clock assembly is dead, you will need to replace the clock assembly 6610445 on the unit. Test and make sure there is voltage coming to the clock assembly. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Gas oven will not heat, no error codes show up and when you press start it goes through 10 minute preheat, but no glow rod comes on nor gas. Is it the controller unit?
Answer Hello. You will need to test and see if there is 120 volts coming to the igniter 98005652. If so, but the igniter is not glowing, then you will need to replace the igniter. If there is no power there, you will need to make sure there is no broke wires. If there is no broke wires, you will need to replace the electronic control. You can test this with a multi-meter TJMA-DM1. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html