Frig is running all the time want shut off set at 38. Stuff in frig are frozen.
Answer Hello Bobby, You will need to check and see if the thermistor 2188819 is bad. If it is good, you will need to order and replace the control board in the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
It should have a resistance reading of 2800 ohms resistance ay room temp. (77 dgrs F,) on the P2 connector pin 1 (orng) across pin 6 (orng/blk). Check and make sure there are no loose connections, or moisture on the thermistor connector.
Hello. I have a problem with ice frost in the evaporator,bimetal Ok. Heater element Ok so I ordered the control box. I wondered exactly about the both thermistor,freezer and cooler section.How it works in this problem ? I defrost manually and is perfect for approx,3 or 4 days. After that again I get frost?
Answer Hi. If there is frost build up on the back wall then you need check that the defrost thermostat is closed when in frozen states. If not then you need to replace the defrost thermostat part # DA47-10160H. The sensors should ohm out to 5.5k ohms @ room temperature. The sensor part # DA32-00006W. The upper sensor is part # TJDA32-10109W. Ohm the heater part # DA96-00020Q for resistance and not an open or shorted issue. You have to buy the evaporator /heater in an assy. This is the only way the manufacturer allows purchase of the heater assy. Unclasp it from the evaporator assy. if needed. If all theses ohm good then replace the main board part # DA41-00134F. Thank You.