Can you please describe how to replace this part? I just ordered a new one but I'm unsure of how to install it. Thank you!
Answer Jennifer, here is some basic information : "REMOVING THE RELAY CONTROL BOARD AND LINE FUSE 1. Unplug microwave oven or disconnect
power. 2. Open the microwave oven door. 3. Pull the two tabs and remove the center air flow screen from the top of the cabinet. 4. Remove the four screws from the right panel cover, then pull the cover forward, and remove it. 5. Remove the screw from the right panel.
6. To remove the relay control board: a) Lift the right panel and relay control board and unhook the two side T-tabs, and pull the right panel and relay control board forward as far as the wires will allow. b) Disconnect all of the wire connectors from the relay control board plugs. c) Squeeze the locking tabs on top of the six standoffs, and pull the relay control board off the standoffs.d) Remove the T10 torx screw from the green ground wire and remove the relay control board." There are a lot of connectors, and your best bet would be to label or mark them as you remove them, it'll make it a lot easier, when you start re attaching them to the new control board. Thanks and Good Luck