I need instructions for changing out the Relay Control Board (P/N 8206602). Can anyone help?
To remove the control panel to get to the relay board you will need to remove the air grill first. Once the air grill is removed there should be a screw holding the control panel in place. Remove this screw and take the control panel off. Once the control panel is off you will then remove the old board and replace it with the new control board.
Microwave sounds like it is working but nothing will get hot. The convection part works fine any idea on what part I will need or how can I check it.
You will want to test the magnetron by checking for less than 1 ohm of resistance. If this does not check ok then the the magnetron is bad and would need to be replaced. You will also want to check the diode to make sure that it is good and check the magnetron thermistor. If they are bad then they would need to be replaced.