Part No. AP3598617; How does it attach to the control panel assembly?
Teresa for Model Number GBD277PDB10
Answer Hello Teresa. Here are the instructions from the manufacture for the control board 8301848. Hope this helps.
1. Disconnect the electrical power to the
double oven.
2. Open the lower oven door.
3. Remove the bottom screw from each of
the two side trim pieces.
4. To remove the side trim, pull the bottom
out approximately 2?, and slide the top
down to free it from the control panel.
5. Remove the screws from the oven control
panel.
6. To remove the oven control panel, pull it
out at the bottom, and lift and unhook it
from the oven cabinet support at the top.
7. Disconnect the wire connectors from the
control board and set the panel face down
on a padded surface to protect the finish.
8. To remove the thermal fuse, disconnect
it from the main harness connector.
9. To remove the oven control/display
boards:
a) Remove the mounting screws.
b) Lift the ends of the locking arm and
disconnect the ribbon cable from its
connector.
NOTE: The control and display boards are
designed to be replaced as an assembly.
10. To remove the touch panel assembly:
a) Push the window and flat ribbon cable
area out of the control panel so you can
grasp the edge of the touch panel on
the other side.
REASSEMBLY NOTE: When you reinstall the
oven control panel, use the following procedure
1. Reconnect the wiring to the control board
terminals.
2. Hook the ends of the control panel over
the rubber tips of the brackets.
3. Push the bottom of the control panel in and
position the plastic air duct under the lip of
the panel.
4. Align the mounting holes and install the
two side screws in the control panel.