Whirlpool 8302994 Oven Control Board - AppliancePartsPros.com

Total
$0.00

Part Number:	AP3851248
MFG Part Number:	8302994
Made by:	Whirlpool

Our Price
$255.67
Regularly	You Save
~~$306.80~~	$51.13

Most Interesting

Code E1 F2 on wall oven.

Marlene for Model Number GBS 277PDq9

Answer Hello Marlene. Keypad keytail not connected. 1.Check keypad connector for firm connection. 2.Press CANCEL. If error code returns after 60 sec., replace keypad. 3.Replace control.

Was this helpful?

My minute timer quite working after a self cleaning cycle. When I push the timer set button it goes into the start time mode as if I were setting up the time cook that then will turn the oven off. Any suggestions?

Jess H. for Model Number rbs275pd

Answer Hello Jess. Based on the information you provided, the control board is bad and will need to be replaced on the unit.

Was this helpful?

Used self-clean feature on wall oven. Afterwards, unit won't heat above 350. If I push up arrow, the temperture starts going down by 5 degrees and the same with the down arrow. The timer also no longer works. Everything was working fine before the cleaning cycle.

Ann P for Model Number RBS275PD Q6

Answer Hello Ann, This would be an issue with the membrane switch which is the control panel.

Was this helpful?

Latest Questions

Bottom burning is not coming on when I turn oven on. Checked the bake element for continuity and shows that the element is not bad. Not sure what to do from here. Top broil element works fine.

Dennis for Model Number RBS305PDS14

Answer Hello Dennis, If you check power from L1 to bake on the control board with the oven on bake then you should have 240 vac. If you do not have 240 vac then you would need to replace control board 8302994.

Was this helpful?

I set the control to bake at 350°F, the broil comes on to preheat, but does not shut off. When 350°F is reached, the bake element cycles. Is the control board is at fault or am I wrong? Thanks!

Murray for Model Number rbs305pdq16

Answer Hello Murray, Sounds like the relay on the board 8302994 has welded contacts.

Was this helpful?

Our electric drop in range (glass top) shut off during the middle of the oven cleaning cycle. (door still locked). The range top burners work fine, but nothing works in the oven and nothing on the control display board. When checking the incoming feed wires under the range top, I noticed the nuts were loose on the wire connection bar. I cleaned and replaced one wire "bandjo" wire connection that appeared to have gotten hot and tightened all nuts, but still no power to oven or control board. Tracing the black and red wires from the power connection bar, going to the control board assembly (P/N 8301919 Rev E) , I have 123 volts on both wires. I pulled the board, (P/N 8301907 Rev B) and one post on the back side marked C21 is slightly discolored with brown stain around it and only slightly discolored on the front soldered side with no obvious burned ribbons. Any thoughts?

Gary S. for Model Number RS696PXGB13

Answer Gary, Based on your description, and the wiring diagram for your range, you most likely have a damaged control board 8302994. The loose connection, high heat and high voltage in the clean cycle probably damaged the board circuit.If the thermal fuse had "opened" that would eliminate power to the elements, but not the control board.

Was this helpful?

Oven Control Board

Questions & Answers

Appliance Compatibility Tool

Repair Help

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information