Hello,Is there a reference I can find to show me how to replace the control card or can you tell me how difficult it is? Is there just one ribbon cable or are there more wires and are they connectorized? Thanks,
Joe
Joe for Model Number JDS9860BDS
Answer Joe, I'm sure you mean the "ERC" (electronic range control) When you mentioned the "control card" . There are 9 to 10 pre wired connector harnesses to be made and a touchpad ribbon as well. If you follow these instructions, you should be fine "Control Panel Assembly Removal 1. Remove power from unit. 2. Remove burner switch control knobs. 3. Remove front screws securing control panel to
chassis. 4. Remove screws located on the left and right sides of the control panel. 5. Grasp control panel on the far left and right sides and
gently pull the control panel out and down. NOTE: The electronic control located in the control panel is a sensitive item, handle gently.
6. Label and disconnect wire terminals. Electronic Control Replacement 1. Remove control panel, see “Control Panel Assembly
Replacement” procedure, steps 1 through 5. 2. Remove screws securing electronic control bracket to control panel. 3. Label and disconnect terminal wiring from electronic control.4. Slide electronic control down and out of bracket, applying slight outward pressure to the inside edges of the electronic control bracket. 5. Reverse procedure to reinstall electronic control. You'll do fine. Thanks and Good Luck