How do I check and see if my electronic control is disconnected or history. I keep getting Err Code F6 E0. Lost communications on my 5 year old oven...I'm a novice...need HELP...
Answer Hello Allen. LOST COMMUNICATION. A. Unplug range or disconnect power.
B. Open the console and make sure the P6 connector on the appliance manager
and the P2 connector on the user interface are fully inserted.
If not, plug in connectors and go to step F.
If fully plugged in, go to step C.
C. Visually inspect all of the four wires between P6 on the appliance manager and P2
on the user interface. Make sure the wires are not cut or pinched. If the wires
appear to be intact, perform a continuity check between Pin 4 of the appliance
manager and Pin 4 of the user interface. Do the same for Pins 1, 2, and 5. Both of
these checks should result in a reading of less than 5O.
If either of these checks fail, go to step E.
If these checks pass, reconnect P2, then go to step D.
D. Replace the appliance manager. Ensure all connectors are properly seated; then go
to step F.
E. Replace the wiring harness (signal) and go to step F.
F. Ensure all wiring connections are made.
G. Replace all parts and panels before operating.
H. Plug in range or reconnect power.
I. Observe for longer than one minute.
J. If the error does not appear, initiate a bake cycle. Let the cycle run at least one
If no error occurs, cancel the cycle. The problem has been repaired.
If the error occurs again, restart the troubleshooting procedure at step A
(except in step D replace the user interface if the appliance manager has already
I have a Kitchen Aid gas oven and after I ran the self-cleaning mode the oven will shut off ramdonly when cooking around 400 Degrees. Once it shuts off (like an over temperature, thermal switch) you can re-start it easily. I replaced the termal switch (only one in the back of the unit, KGRS807SSS00) and this did not fix the unit - still ramdonly turning off when in the bake oven mode, does anyone have any idea as to what defective part is causing this shutdown? Thanks for any help.
Answer RKR, There are a couple of other possibilities. Is the cooling fan running 9759320 and keeping the control panel area "cool" ? You will need to remove the control panel and check the Thermal switch and thermal cutoff mounted to the front of the top burner box, if the thermal switch "opens", it eliminates power to the control transformer and the range will shut down, until the switch resets. A weak thermal switch, or cooling fan that is not circulating the hot air under the cooktop, could cause your issue.