The washer will not go into the spin mode, I will get a 5d or sd code and then it starts to add water and start the rinse cycle over again. Always with stops with about 12 min. left on the cycle. I have put the machine through several machine cleaning cycles, but still get the same results.
The error code Sd is displayed when the machine/motor control, by analyzing drag on the basket, detects a suds lock condition, and is steady on while the control then runs a mini clean out cycle. If the clean out cycle is unable to correct the issue then the SD will display. This could be an indication of one of the following: Load is bunched or twisted around the agitator, Excessive detergent usage, basket cannot engage during drain step, mechanical friction on drive mechanism not allowing basket to engage. By running the clean cycle several times this would eliminate the possibility of the sudsing issue and the bunched clothes since it is happening during the clean with no clothes in it. For the other issue you will want to check for there to make sure that the tub is turning freely, and check to make sure that there is nothing caught between the tubs.