I am not getting any power to the dryer. 240v ok. Limits and fuses ok. Any idea what it could be ?
Answer Hello Philip. If you are sure the voltage, terminal block, thermal fuse, and wiring is good, then you will need to replace the control board W10111617 on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
I was wondering if I could get installation instructions for part #AP4359310
Answer Hello Sarah,
I will try to get close without the model number of your unit. Remove the power supply to the unit and remove the main top by removing the two or more screws near the top of the unit from the rear. Remove the screws holding the board bracket in position. Remove the screw/screws holding the board to the metal bracket. At this point, take several pictures from several directions to aid in the new part installation. Remove the wiring connectors and connect to the new board. (Do this one wire/connector at a time so all of the wires remain connected at all times). This will even more prevent re-assembly issues. Re-assemble in the reverse order.