Hi: Top burners work fine. Oven and Broiler do not. I can hear ignitors go "click, Click" but seems like no gas is coming through. Is there a gas supply valve that supplies gas to oven and broiler. How would it read on parts list. Any other ideas? Thanks Jim
Answer Hi Tim.WPL - DIRECT - SPARK - IGNITION :
Here is how you check that Test for 3.2-3.6 volts AC at the gas safety valve with the igniter turned on. If the voltage is there, you have a bad safety valve. If the voltage is low, you have a weak igniter and the igniter will need to be replaced. You can test this with a multi-meter TJMA-DM1.Now you need to run the DCV checks from the DSI module. On J1 pin1 red wire, you should read 8 to 18 VDC in the bake mode, and J1 pin3 blue wire, should have the same VDC, in the broil mode and J1 pin 2 orange is the common lead for both tests. At the gas valve assembly W10293048 check the resistance from the center terminal to each outside terminal you should have a resistance of 215 ohms on each test. Also check for the same VDC from the module. If all checks OK, replace the gas valve assembly. Thank You.