Bake and Broil doesn't function...2 clicks but neither work...The stove top works fine...Have a blown a thermal fuse and if so, where is it located?
Answer Nicki, No, your range doesn't have a thermal fuse. The most likely issue is a spark module issue W10331686 located in the control panel. Here's some testing information " First thing, check and make sure the power cord is attached to a properly polarized and grounded 120 VAC outlet. A proper ground is very important for the range to operate properly. Then you'll need to make several tests at the gas distribution valve.You'll need a multi meter to test voltage and resistances. At the valve body terminals, with the wires labeled and remove from the middle terminal to each of the outer terminals, you should read 215 ohms resistance.With the wires reconnected, when you select the bake cycle, you should have a reading of 8 to 18 VDC across the red and orange wires.
When you make a broil selection you should have the same 8 to 18 VDC,across the orange and blue wires. If all checks are proper replace the gas valve assembly W10293048 . Thanks and Good Luck