Maytag washer is not working. The display panel has given F-01 and F-21 error codes, now after disconnecting power cord and reconnecting. I can turn knob to various cycles and receive times for cycles but the washer no longer operates. which part do I need to replace?
Answer Hello Gilbert. A communication error between the Central Control Unit (CCU)
and the EEPROM onboard the CCU occurred. Possible Causes/Procedure
A power glitch may cause this error.
– Unplug washer or disconnect power for two minutes.
– Verify CCU operation by running a Diagnostic Test or any
cycle. PUMP DRIVE ERROR
The pump driver fails to activate.
Replace CCU board. MAIN RELAYS ERROR
One of the main relays is not working properly.
The relay might be soldered or always open.
– Replace CCU board.
I broke the control knob off and do I have to replace the whole console
Answer Hello Jim, according to the complete model number the correct console for your unit is W10387857. Unfortunately you'll have to purchase the complete console to replace the broken knob. Thanks!