I have an F05 error code which is a water temperature sensor or heating element relay. How do I check these? Where are they located on the machine. What parts do I need?
The water temperature sensor is located on the lower front of the tub. To access remove the lower front panel. Once you have access to the temp sensor, you will check the connections and wiring between the main control and the sensor. If wiring checks ok then check the following: Disconnect the wire harness from the water temperature sensor and measure the resistance of the sensor. Use the following table. An
abnormal condition is an open circuit.
32ºF (0ºC) 35,975 k
86ºF (30ºC) 9,786 k
104ºF (40ºC) 6,653 k
122ºF (50ºC) 4,608 k
140ºF (60ºC) 3,243 k
158ºF (71ºC) 2,332 k
203ºF (96ºC) 1,093 k
the washer does not go on high spin. tried door lock and switch/ replaced the user inter face#AP4364214/ still doing the same thing
Answer Mario, You'll need to check the wiring harness between the CCU W10192966 and the MCU W10192965 and from the MCU to the motor. If there are no loose connections or damaged wires, you'll need to start at the MCU and replace it.