THE BUTTONS ARE PEELING OFF THE FACE OF THE CONSOLE. IS THE TOUCHPAD IN THIS MODEL EASY TO REPLACE AND DO YOU HAVE INSTRUCTIONS FOR INSTALLING A NEW ONE. AND IS THIS A FAIRLY STRAIGHT FORWARD AND SIMPLE PROCESS THAT A NOVICE CAN DO. THANKS
Answer Thomas, Yes, it is a project a novice can do, here's some help " Electrical Shock Hazard disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 1. Unplug dishwasher or disconnect power.
2. Open the dishwasher door. 3. Remove 8 screws from the sides of the door panel.4. Hold the front panel to the door panel and
close the door. 5. Lean the front panel away from the dishwasher. 6. Lift the door panel up and off the front of the dishwasher. Removing the Control Panel 1. Unplug dishwasher or disconnect power. 2. Open the dishwasher door. 3. While supporting the control panel, remove six screws from the upper sides and center of the inner door panel. 4. While continuing to support the control panel, close the door. 5. Gently pull outward to disengage the control panel. 6. The control panel will be connected with wires that may need to be disconnected to set the control panel down." You'll do fine. Thanks and Good Luck
There's a difference in the our touch pad and the touch pad pictured on your site. Is there a difference or is it just a generic picture?
How difficult is it to install the touch pad?
Will the part come with instruction to install?
Answer Hello Richard. Based on the model number you provided, 3385743 is the correct control panel. You will need to disconnect the power to the unit. Then remove the screws securing the inner door panel. Remove the inner door panel and remove the cover off the control board. Remove the ribbon cable from the control board and remove the screws holding the control board housing in place. Next remove the screws holding the control panel in place. Reinstall with the new control panel in reverse order.