Does this part AP3008776 include the soft touch membrane or is it only the glass?
Answer Hello Samuel! The glass console 9781973CB will include the touch panel. However, the electronic control 9781980 is not included. Thanks!
How to change part no ap3008776?
Answer Hello Vince. Remove the screw from each end cap. Open the oven door and remove the
three screws from the bottom of the
control panel. Pull the knobs off the gas valves. Lift the front of the control panel, pull it
forward, and slide the front edge of the
cooktop glass out of the slot in the front
of the panel. Rotate the control panel up and over so
the bottom side faces up. Disconnect the wire connectors at P1,
P11, and P3. Remove the paper support from the
ribbon cable at connector P5. Squeeze the end tabs on the ribbon
cable locking ring and pull the locking
rings and ribbon cables out of their
connectors at P4 and P5. Straighten the nine bracket tabs so that
they fit through the board slots, and
remove the electronic oven control
board from the bracket. Remove the two screws from the electronic
oven control board bracket and
remove the board and bracket from the
control panel assembly. Remove the two screws from each of
the two end caps and remove the caps. Reinstall in reverse order with the new console 9781973CB. Hope this helps.