Hi Team! I push the smart wash button and the start button, it fillls up and starts the do it's thing, but will not cycle to "Sensing".
It just stays in the wash cycle!
Richard for Model Number 665.16263402
Answer Richard,
You will want to check your soil sensing switch 8542575 to make sure that it is good. If good then you will need to replace the control board 8564547. To check the switch you would do a continuity test. The switch will read normally open unless there is significant soils in the pump. If the switch reads closed then check to make sure that there is not a lot of build up in the pump and if this checks ok then replace the switch. If the switch checks open then replace the control board.
The clean light flashes 7 times. I know this is a diagnosis code. I would like to know what the diagnosis is?
Pete for Model Number whirlpool dishwasher 6651603340
Answer Pete,
The clean light flashing 7 times would be a heater circuit issue. You will want to check the continuity of the heater to make sure that it is not bad. Check the water temp coming into the unit to make sure that it is at least 120 degrees. Check the thermal fuse for the heater to ensure that it is not blown. Check the wiring from the heater to the controll board. IF all this checks ok then the control board would be at faulty.