We switch the dishwasher on and it just sits and goes in to "drain" mode. I reset by pressing 3 buttons three times each and reset the machine. I hit "start / resume" button and all it does is operate for 2 mins and then drain out...
Answer Steve, You'll want to replace the control panel / keypad assembly W10290155 first, The rinse keypad circuit is "stuck" causing the control to program the rinse cycle(fill wash for 2 minutes and drain). You'll still need to reset the control after you install the control panel, and allow it to run the complete test/diagnostic cycle. Thanks
Runs thru pot clean cycle, pumps out and fills and washes in next cycle for 2 mins then switches itself to cancel/drain. Pumps out and stops. Will not go thru all cycles. Stops after two cycles or so. Fills, washes, pumps out fine?
Answer Hi Jeff. It will be advantageous to find the supplied tech sheet inside the cabinet to aid you in the diagnosis. It allows you to put the unit in a diagnostic mode which brings up fault codes and tells you which circuit needs assistance. Unplug the control panel ribbon cable and see if the unit will run normally now. If so then you have a stuck keypad part # W10290157. If it is the control board then it is part # W10395153. Thank You.