How hard is it to replace the control panel. Can you tell me where to go for instructions?
Johnny Bryant for Model Number MEW5527DDW
Answer Johnny, Its not hard at all, here are the instructions ; "Control Panel Assembly 1. Turn off power to unit. 2. Remove screws securing trim piece(s) to the cabinet. 3. Slide unit out of cutout approximately 6 to 8 inches. NOTE: To avoid risk of property damage and personal injury, place blocking material undernieth the front edge of the wall oven to prevent unit from tipping forward. 4. Remove screws securing control panel assembly to unit chassis. 5. Label and disconnect wire terminal plugs from control board assembly. NOTE: While unplugging electrical connections, pins may be damaged, use extreme care when disconnecting. 6. Place control panel assembly on a protected surface. 7. Reverse procedure to reassemble. Touch Panel 1. Remove control panel, see “Control Panel Assembly” procedure, steps 1 through 3. 2. Remove screws securing touch panel to control panel assembly. NOTE: Touch panel is loose, but the ribbon cable does
not allow complete removal. 3. Disconnect ribbon cable from touch panel and remove touch panel. 4. Replace touch panel and reverse procedure to reassemble. Side Trim(s) 1. Remove control panel, see “Control Panel Assembly" procedure, steps 1 through 3.
2. Remove screws securing trim piece to unit chassis. 3. Replace side trim and reverse procedure to reassemble. Good Luck and Thanks
Do you have this in Black?
Dave S. for Model Number mew5527ddw
Answer Hello Dave, here is the part number for the black control panel, 5765M440-60. Thanks!