Whirlpool 8300428 Control Panel Assy. W/membrane Switch (white Model)

Total
$0.00

Part Number:	AP3046697
MFG Part Number:	8300428
Made by:	Whirlpool

Our Price
$148.52
Regularly	You Save
~~$176.74~~	$28.22

Most Interesting

Recently the the oven in my built-in electric convention oven will not shut off. The heat stays on no matter which button I push. I have to shut off the breaker to get it to shut off and then it starts up again. I left the braker off for about 20 hours and just turned it on again. Everything was fine until I truned on the ovens. Once on the fan seems to keep running and the elements in both oven seem to still be heating at minimal level even if I use the control panel and shut them off (the panel still beeps). Then I shut the breker off for 10 seconds or so and turn it back on. The fan then starts again and the elements begin to heat up. Should I replace the control panel assembly??

Jim for Model Number GBD307PDQ09

Answer Hello Jim, As long as there are no wires pinched or otherwise shorted to ground, the relay board W10406070 has to be the issue.

Was this helpful?

This is a follow up question to one I had asked before. The lights on the control panel keep getting dimmer and dimmer, getting very hard to see. What do I need to do to fix this problem on my Whirlpool oven. Oven works fine except for the dim lights on the control panel. Thanks

Danny for Model Number RBD245PDQ15

Answer Hello Danny. The control board W10406070 will need to be replaced.

Was this helpful?

Does anyone have a step by step on how to replace the Control Panel Assy. W/membrane Switch (white Model). I think this is what I need to do to fix my problem of all the control lights getting dimmer. Getting hard to see what temp the oven is on. Thanks

Danny for Model Number RBD245PDQ15

Answer Hello Danny. Disconnect the power and open the doors to the unit. Remove both of the side trim pieces off the oven. Once removed, you will see two screws at the bottom corners of the control panel. Remove both screws and lift the control panel upward and off the unit. You can now access and replace the control panel 8300428 on the unit. Some are easier to replace if you pull out the oven about 3".

Was this helpful?

Latest Questions

I'm getting intermittent Error code F2 E6 as well as intermittent dimming of the display (not at same time). Some sites suggest this is control board problem. Is Control Panel Assy. W/membrane Switch the same as or does it include the control board? Thanks, Tom

Thomas for Model Number rbd245pdq14

Answer Hello Thomas. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/1094-whirlpool-fault-code-e6-f2.html

Was this helpful?

The oven panel shows F-2, E-6. We have tried the suggested trouble shooting options. Could this be a control panel fault or a micro computer problem? Thanks for your help. Stephen

Stephen for Model Number RBD245PDQ7

Answer Hello Stephen. The error code is for a bad cancel key. You will need to replace the control panel 8300428. Hope this helps.

Was this helpful?

Instructions for replacing the control panel assy. Thanks Bruce.

Bruce G. for Model Number AP3046697)

Answer Hello Bruce. First disconnect the power to the unit. You will need to remove the inner door panel. Once removed, you will need to remove the control board assembly and the screws holding the control panel in place. Reinstall in reverse order. Hope this helps.

Was this helpful?

Control Panel Assy. W/membrane Switch (white Model)

Questions & Answers

Appliance Compatibility Tool

Repair Help

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information