Will part 8300449 (control panel) work with my double oven?
Answer Hello Jim! Yes, the control panel 8300449 is the correct replacement and will work on your range. Thanks!
Oven was not heating up and the fan was constantly running. Error code pointed to control board. Got a replacement board and error code changed to "E1-F2" Would this indicate needing a new keypad assembly?
Answer Edward, Yes, the F2-E1 error code would indicate an issue in the key pad / control panel assembly 8300449. " F2 E1 Keypad keytail not connected, 1. Check keypad connector for firm connection 2. Press Cancel. If error code returns after 60 sec. replace keypad. 3. Replace control. Also recheck the connections at the new control board, make sure you didn't miss a connector pin, and that the ribbon is inserted and seated properly in the connectors.
Do you have instructions for installing this part
Answer Trey, Disconnect the electrical power to the oven. Open the lower oven door. Remove the bottom screw from each of the two side trim pieces. To remove the side trim, pull the bottom out approximately 2?, and slide the top down to free it from the control panel.Remove the screws from the oven control panel. To remove the oven control panel, pull it out at the bottom, and lift and unhook it from the oven cabinet support at the top. Disconnect the wire connectors from the control board and set the panel face down on a padded surface to protect the finish. To remove the oven control/display boards Remove the mounting screws. b) Lift the ends of the locking arm and
disconnect the ribbon cable from its connector. NOTE: The control and display boards are designed to be replaced as an assembly.