Control, Range (black)

L Albright for Model Number whirlpool Range RF386PXE

Answer L, The F2 error code indicates an issue with the oven Temp sensor 8053344 or the control 6610056. You'll need to use a multi meter and check for 1050 to 1100 ohms resistance across the wires on the sensor ( preferably at the clock connector) if the resistance is not in range replace the sensor and check the wiring connections, If the resistance is in range, you'll need to replace the control. 

Carl for Model Number RF386PXEW0

Answer Hello Carl, The fault indicates that the top oven sensor is shorted. This can only be corrected by replacing the top oven temperature sensor 8053344. If the wiring between the sensor and clock assembly is checked out and OK and not pinched at any point, the service manual now says that if the code continues, replace the clock assembly 6610056. 

Mike for Model Number rf328pxewo

Answer Hello Mike! Yes, an F5 failure code on Whirlpool Ranges indicates a board failure. The model supplied, rf328pxew0, seems to be invalid. We will need the correct model number to verify the correct board used on your appliance. Thanks! 

John for Model Number RF387LXGN0

Answer Hello John! Yes, it does sound like the electronic control needs to be replaced. Your part number is 6610056. Thanks! 

Joe for Model Number RF386PXEW0

Answer Hi Joe. First try pressing Cancel to clear the display. This F-0 is only displayed if "upper off " key is presed anh held for 5-seconds with no pre- existing faults. The range control is part # 6610056. Thank you.