What type of sealent is used for the edge of the glass top? What type of adhesive holds the circuit board to bottom of glass?
Answer Hello Larry! The manufacture no longer uses adhesive, the new tops uses supports that come with the top only part number 4455552. The board 3192771 is held in place by supports 3191693, which have been discontinued with no replacements available from the manufacture. Thanks!
I need installation instructions for this part. Please.
Answer Hi John. It is relatively a simple task. You remove power. Then set towels surrounding the circumference of the unit ion the counter top. Lift the unit up and set it "kitty-corner" on top of the counter top. Than use a 1/4" nut driver to unscrew the side screws that hold the top down. Remove all knobs and rubber grommets that surround the shaft holes. The burners will stay inside the unit. As you are lifting the top off, carefully note where the electrical connections go. Take a cell phone picture if needed. Use a shop vac to clean all broken glass if needed. On the back of the new top is the "top"of the control panel for the switches. You will need to use a pair of needle nose pliers to depress the circuit board stand off clips on all 4- corners that hold the board "sandwiched" together. You will need these boards to insert on the new top assy. Be xtra careful of any electrical connector and take note of them. Use a cell phone to picture the connections if needed. Than Its just a matter of swapping out parts. Reassemble in reverse. Thank You.