Cooktop, Ceran

Justin for Model Number kesc307bwh3

Answer Hello Justin. No, the cooktop for your model number is 9751752 and has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. 

Jj for Model Number KERC608LSS

Answer Hello JJ. To remove the console on a freestanding range, you will need to remove four screws along the bottom of the control panel (see the photo above). You will need to open the oven door to access these four screws. You will also need to remove the side trim screws. To remove the side trim screws, remove the side panel and two screws from the cooktop trim. Slide the cooktop trim back to expose the side trim screw, and remove the screw (1 on each side). 

Deborah for Model Number whirlpool ceran

Answer Hello Deborah! Here is the link to our model number location tool. This will help you locate the appliance model number. Once obtained you may repost for further assistance. Thanks! http://www.appliancepartspros.com/modelnumber_locator.aspx 

Roy D. for Model Number kerc608lss

Answer Hi Roy. 1. Unplug range or disconnect power. 2. Pull the range out of its mounting location so that you can access the side trim. 3. Remove the control panel from its subchassis, and set it on the subchassis. 4. Remove the two screws from the left and right side trim. Do not remove the trim at this time. 5. Raise the cooktop and prop it up. 6. Loosen the left and right tension bracket screws and remove the brackets from behind the side trim. 7. Remove the wire clip from the left side trim. 8. Pull the left and right side trim off the cooktop. To remove the trim, lift it away from the cooktop glass, and pull the back off the rear trim. 9. Lower the cooktop. 10. Lift the front of the cooktop glass, pull it forward from under the rear trim, and remove the glass from the cooktop. IMPORTANT: When you reinstall the cooktop glass, keep the side edges of the glass inside the four alignment tabs (two on each side). If the glass AP3837474 is over the tabs, it could break when you lower it. Thank You. 

Greg for Model Number KESC307HWW8

Answer Hello Greg, I have an illustration for you if you could shoot me a valid e-mail address. Thanks. 

Greg for Model Number KESC307HBS4

Answer Hello Greg. 1. Unplug range or disconnect power. 2. Pull the range out of its mounting location so that you can access the side trim. 3. Remove the control panel from its subchassis, and set it on the subchassis. 4. Remove the two screws from the left and right side trim. Do not remove the trim at this time. 5. Raise the cooktop and prop it up. 6. Loosen the left and right tension bracket screws and remove the brackets from behind the side trim. 7. Remove the wire clip from the left side trim. 8. Pull the left and right side trim off the cooktop. To remove the trim, lift it away from the cooktop glass, and pull the back off the rear trim. 9. Lower the cooktop. 10. Lift the front of the cooktop glass, pull it forward from under the rear trim, and remove the glass from the cooktop. IMPORTANT: When you reinstall the cooktop glass, keep the side edges of the glass inside the four alignment tabs (two on each side). If the glass 8190780 is over the tabs, it could break when you lower it. Hope this helps.