I found the sensor arm and I was able to put the end of it into the fill cup, but I was unable to find the hole in the module for the other end. Please help me locate where it should go. Also, do I need to have it in the up position or down, and will it be difficult to then release the ice from the tray? I don't want to break anything in the process.
Answer Hello Paul. The slot for the other end is in the top corner of the control module. If you look in the second part picture D7824706Q of the icemaker, you will see it in the bottom right corner. This is a picture of the icemaker upside down. It is the white round circle with the slot in it. Once the arm is installed, you will need to put the arm in the down position. The icemaker will cycle and the heater will release the ice in the mold. Hope this helps.