Is the Deflctr-Ar Part AP3-11440 The correct part to change the microwave from inside exhaust to vertical exhaust via the 10" X 3.5" connection to the thru the roof installation? Also would I need any addtional parts to complete the job after I remove the microwave?
Thanks for your help.
Answer Bob, Unless the parts were misplaced or lost, you shouldn't need the deflector 8184638 or damper 8205741. Once you remove the microwave from the mounting plate and cabinet : 1. Remove 5 screws attaching damper plate to top of microwave oven exterior, then lift off damper plate.2. Keep damper plate and screws together and set aside. 3. Slide air deflector out of microwave oven. 4. Rotate air deflector so that deflector vanes face the top of the microwave oven, and the exhaust port (open end) of air deflector aligns with microwave oven exhaust port. 5. Slide air deflector into the back of the microwave oven making sure its exhaust port (open end) aligns with the microwave oven exhaust port. 6. Reattach damper plate at corners with 4 screws. Save the fifth screw for later use, Install unit
1. Insert damper assembly through the cabinet cutout so that the long tab of the damper assembly slides under the raised tabs of the damper plate. Then secure with screw removed in Step 1 NOTE: The screw cannot be installed if the damper assembly is not positioned, installed properly. 2. Connect vent to damper assembly. check for operation and air leaks.