Defrost Control Board

Matt E.

Answer Hi Matt, yes this is the adaptive defrost control 2304093. Thanks! 

1 person found this answer helpful.

Phil W for Model Number KTRC22ELSSOO

Answer Hello Phil. To replace the control board 2304093, you disconnect the power and remove the screws securing the control panel inside the fresh food section. Drop down the controls and access and replace the board in the unit. 

Phil for Model Number 2304093

Answer Hello Phil. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx 

Sean B for Model Number gr2fhtxtloo

Answer Sean, Here are the procedures to force a defrost cycle for your refrigerator : Option #1 ( Bi metal closed)1. Power off to refrigerator for at least 30 seconds. #2 Thermostat off. 3#power on to refrigerator. Option #2 (Bi metal closed) #1 Thermostat off 15 seconds. #2 Thermostat on 5 seconds. (Repeat steps 1 and 2 two more times) #3 Thermostat off. In 3 to 8 seconds, control will turn on defrost heater. Defrost heater will turn on for 18 minutes or until the bi metal opens. To terminate test early, remove power from refrigerator. The defrost thermostat may be "sticcky" but it's most likely an issue in the ADC control board. 

DDAVIS263 for Model Number ET1FHTXMQO4

Answer Hello Ddavis263. Yes, 2304099 is the defrost board and is located inside the control panel in the refrigerator compartment. 

BEACHBUM62 for Model Number gt1shtxmqo3

Answer Hello Beach bum. Turn the thermostat off 15 seconds and then on for 5 seconds, repeat for two to three times. When unit shuts off, it is in defrost cycle. Hope this helps.